
Phoenix Contact released firmware 26.10 for its FL WLAN line of industrial wireless access points and clients to fix a high-severity flaw. The advisory, VDE-2026-126, was published by CERT@VDE, the German industrial computer emergency response team, on Wednesday, 18 November 2026, with the matching Phoenix Contact security advisory PCSA-2026-00021.
The flaw, CVE-2026-113497, is rated 8.8 on the Common Vulnerability Scoring System (CVSS) version 3.1. It falls under Missing Authentication for Critical Function (CWE-306). Phoenix Contact says a remote attacker who has only a low-privileged account on the device can use the REST API, the web programming interface the device uses for management, to change the password of any user, including the administrator. Once the attacker sets a new administrator password, they have full administrative control and can change every configuration setting. Phoenix Contact describes this as a complete loss of confidentiality, integrity and availability for the device.
Affected models, all with firmware below 26.10:
The fix is firmware 26.10 for every listed model. Phoenix Contact also says these devices are designed for closed industrial networks and strongly recommends using them only in closed networks protected by a suitable firewall. The flaw has not been reported as exploited, and it is not on the Cybersecurity and Infrastructure Security Agency (CISA) Known Exploited Vulnerabilities catalog.
Why this matters in the plant: industrial wireless often carries control traffic where cables are hard to run, such as cranes, automated guided vehicles, rotating equipment, tank farms and remote panels. In many sites, the same few shared logins are used by operators, technicians and vendors, so a low-privileged account is not a high bar. Someone who takes over the access point can change the wireless security settings, redirect or drop traffic, or lock the plant staff out of their own device. Losing a wireless link to a moving machine or a remote panel can stop production just as surely as a failed cable.
Red Tiger can help you see where wireless really reaches your control system. During our onsite facility assessments, our team walks the system from the perimeter through the demilitarized zone (DMZ) and control room down to the field devices, and we often find wireless bridges and access points that were added for a project and never brought under the same rules as the wired network. We can then help remediate and harden what we find, and we can install a firewall and sensor at the site, connect them to the Red Tiger 24x7 SOC, and monitor the site for ongoing detection and response, with regular metrics and reports. Our team has completed more than 500 assessments and trained more than 4,500 people.
We are here to help, so check out our resources online at www.redtigersecurity.com and book a follow-up call with our team if you have any questions: https://calendly.com/jonathanpollet/30min
Source: CERT@VDE advisory VDE-2026-126 and Phoenix Contact advisory PCSA-2026-00021, 18 November 2026: https://certvde.com/en/advisories/VDE-2026-126/
Check out our resources and book a follow-up call with our team.